In power supply systems, it is usually necessary to lay cables to transmit electromagnetic energy or establish power supply to consumers. After the cable is laid, in order to better turn it into a continuous route, each section of the cable must be connected as a whole, and this connection function is called a cable joint. The cable joint located in the middle of the customized cable route is called the cable intermediate joint. The cable intermediate joint is a cable accessory used for the central connection of various rated voltage chemical cross-linked cables or oil transformer cables. Its key function is to ensure smooth power supply routes, maintain cable sealing, and ensure the flame retardant level at the cable joint, making it reliable to operate. It has the functions of moisture-proof, anti fouling, and anti shaking.
In order to ensure the stability of power supply, it is stipulated that the plastic inner stress cone and prefabricated components of the plastic insulation layer in the middle joint of the cable should be free of bubbles, embrittlement, and other harmful residues. The inner and outer surfaces should be smooth and clean, and the insulation layer and semi conductive page should be well integrated. The semi conductive shielding should be free of harmful residues inside. According to the current observation results of the microscope of the cable intermediate joint test sample and the investigation status of the cable accessory manufacturer, it is difficult to avoid small bubbles and page protrusions on the cable intermediate joint. Therefore, in order to ensure the stability of power supply and the quality of the adopted cable intermediate joint, there must be a relative inspection method for the internal structural defects of the cable intermediate joint.
At present, the main way to inspect the internal structural defects of cable intermediate joints is through partial discharge testing when powered on. Because the manufacturer of right angle pipe joints generates local charging and discharging signals in the insulation layer structure, such as pulse current and electromagnetic wave radiation, they can immediately receive abnormal signals during partial discharge using the signal receiving camera and conduct research on abnormal signals to identify the location of internal structural defects.
